The cutting edge of a lathe tool should be set right on or just slightly below the center line of the part being machined. With new lathe tools this is not a problem, because the tool posts are made to hold them at the correct height. Older tools that have been sharpened numerous times may require shimming to bring them up to the correct height.
The Rocker Tool Post is designed to eliminate the need for shimming. The height of the cutting edge can be changed by simply adjusting the two clamping screws. This inexpensive accessory reduces setup time and also extends the life and the usefulness of your old lathe tools.
• These rocker tool posts are great for grabbing a little extra rake angle and for working in tight or hard to reach places.
• Rocker tool posts hold a single toolholder or cutting bit and the center height for cutting can be adjusted without shims.
